Still doing some research here and going to keep tacking on some info.
My actual goal is to run a motor like this: https://www.transmotec.com/product/jd5fn-3230-cvc and it says it wants 1.5A but the Qwiic Motor Driver only wants to do 1.2A steady // 1.5A peak.
I only need to run one motor, though, and the motor driver can run two? So if things are wired in parallel then I could stay within spec?
https://www.sparkfun.com/products/15093 or maybe this is the way? Since I just need to turn one motor on/off for 30s at a time - this can handle the amps and its simplicity is actually a benefit not a limitation! I think I'm going to go with this unless someone has a good reason not to
My actual goal is to run a motor like this: https://www.transmotec.com/product/jd5fn-3230-cvc and it says it wants 1.5A but the Qwiic Motor Driver only wants to do 1.2A steady // 1.5A peak.
I only need to run one motor, though, and the motor driver can run two? So if things are wired in parallel then I could stay within spec?
https://www.sparkfun.com/products/15093 or maybe this is the way? Since I just need to turn one motor on/off for 30s at a time - this can handle the amps and its simplicity is actually a benefit not a limitation! I think I'm going to go with this unless someone has a good reason not to
Statistics: Posted by MeoMix — Fri May 24, 2024 8:03 pm